炒酸奶机

中国出口炒冰激凌卷机

尊敬的用户你好：

欢迎你选用我们厂生产的制冷设备，我们厂是专业生产冰激凌、冷热饮机、炒冰机。雪花酪机等。本公司以“质量第一、信誉第一、顾客至上”为宗旨，真诚为用户提供一流的产品和优质的售后服务，使用前保管好说明书，已被随时参阅。

请详细阅读使用说明书：

一、注意事项和安全警告

安装、使用产品前，请阅读使用说明书。

1、确保使用电源与机器上铭牌相同。

2、保持工作环境通风良好，干燥清洁，避免热源及阳光直射，各进风栅与墙壁或类似障碍物应保持20cm以上的距离。

3、机器搬运及移动过程中，倾斜不允许超过45度。4

4、机器运转时，电源电压应保证198-242V。

5、机器使用的电源插座，必须是单相三孔插座，其中接地的保护插脚必须用专用线通过有关途径与地面牢靠的链接，不得与其他电器插同一插座上。

6、除霜开关按下后，机器开始除霜，除霜完毕应立即关掉除霜开关（切不可长期使用除霜开关，否则会导致压缩机的损坏）。

7、为保证人身安全，请将本机可靠接地。

8、如果电源软线损坏，为避免危险，必须由制作厂家进行维修或由其他相关专业人员来更换。

9、机器运转时，切记将硬物或类似物品伸入进出风栅和进料口栅格内。

10、维修或保养机器之前，请务必切断电源。

二、使用条件

泰卷机作为一种商用制冷设备，它能在一下条件下正常工作

当环境温度，进料温度都处在允许范围内较低值，通风散热条件良好，供应电源稳定以及工作环境洁净，机器的工作效率及使用寿命都将大幅度提高，同时耗电量也会因此而减少。

三、检查及安装

A、开箱及检查

1、剪断并拆开紧固包装箱的打包带。

2、拆下包装纸箱。

3、去掉减震泡沫块，剥离套在炒冰机上面的包装袋。

4、请详细检查炒冰机外观是否有损坏。

5、打开附件包，取出装箱清单，核对随机附件。

B、安装

1、电器安装要稳固，以保证机器工作正常，而不发生意外。

2、机器的位置要有良好的通风散热条件，避开热源及阳光直射，各出风口与墙壁或类似障碍物应有都的20cm以上距离。

3、将机器的电源线对应链接好，并确保可靠接地

4、电源电压不得低于200V，频率要符合机器的工作要求。

为了您和他人的安全，请确保机器接地良好，所有外接线及电器应符合国家相关标准

四、操作使用说明

1、将泰卷机的电源插头插入配有专用接地三孔插座内

2、电源接通后，打开炒卷机开关，让机器先预冷10-15分钟左右，温度显示-26度或以下

3、将配制好的浆料倒入锅内进行炒冰机内

4、待炒冰卷炒好后，即可用铲子铲起来盛入盘中予以食用了

5、如果发现炒好的冰卷与锅体粘连，这时需要打开除霜开关进行除霜（每次除霜大约4-6秒），除霜后应立即关闭除霜开关，方可连续炒冰激凌卷

五、基本配方

在此我们向你介绍一套经济实用的配方及具体配料的方法，通过掌握和熟悉该配方和配料的方法后，举一反三，一定能得心应手的炒出各种风格的冰激凌卷。

基本配方：水果泥（或酸奶）40%   水20%   果酱10%    奶油10%   白糖10%    冰激凌粉10%    香精少许（核桃仁、花生仁、葵花籽仁、芝麻等）

注意：

1、该配方中，水和白糖所占比例已是经济型，若在降低就会影响炒冰的质量。

2、浆料配比含糖量不得低于10%。

3、通常情况下配制好的浆料温度为常温，若将浆料提前预冷，炒冰卷效果更好。

六、清洗、消毒与保养

机器第一次使用前，应进行一次认真彻底的清洗与消毒，具体方法如下：

1、将适量食品洗涤剂滴入2升左右的温水中，配置成清洗消毒液

2、将清洗消毒液倒入炒卷锅中进行清洗

3、清洗完毕，再用清水倒入锅中进行涮洗，如此反复操作2次即可

为了保证消费者的健康，提高机器的使用寿命，避免给你带来不必要的麻烦，请你严格按如下说明操作。

1、每天在制作完成后，先将电源关闭，再用清洁的温热水清洗机器表面，以免过多糖分粘附机器表面。

2、不要用水直接冲洗机器，清洗机器时用湿毛巾擦拭即可。

3、定期清扫机器内部的冷凝器，用螺丝刀拆下围板，用细毛刷沿着翘片方向扫下灰尘，这样可以保证机器的制冷功能不受影响。

七、常见故障及排除方法（请详细阅读说明书）

Dear customer hello:

Welcome you to choose refrigeration equipment produced by our factory, our factory is specializing in the production of ice cream, hot and cold drink machine, ice frying machine. Snowflake cheese machine. The company to "quality first, reputation first, customer first" for the purpose, in good faith to provide users with first-class products and quality after-sales service, the use of good care before the specification has been seen at any time.

Please read the instruction manual:

Matters needing attention and safety warning

Please read the instructions before installing and using the product.

1, to ensure that the use of power and machine on the same plate.

2, to maintain a good working environment, dry and clean, to avoid heat and direct sunlight, the wind inlet and the wall or similar obstacles should be maintained above 20cm distance.

3, the machine handling and moving process, tilt is not allowed to exceed 45 degrees. Four

4, when the machine is running, the power supply voltage should be guaranteed 198-242V.

The power socket 5, machines, must be a single-phase three hole socket, wherein the grounding protection pin must use special line through the relevant channels and ground solid links, not the same with other electrical plug socket.

6, defrost switch pressed, the machine began to defrost, defrosting should immediately turn off the defrost switch (must not be used for a long time defrost switch, otherwise it will lead to damage to the compressor).

7, in order to ensure personal safety, please put the machine reliable grounding.

8, if the supply cord is damaged, to avoid danger, must be produced by the manufacturer for repair or replacement by other related professional.

9, when the machine is running, it will be a hard object or similar items into the import wind and the inlet in the grid.

10, repair or maintenance of the machine, be sure to cut off the power supply.

Two, the use of conditions

As a kind of commercial refrigeration equipment, it can work normally under the condition

When the ambient temperature, the feed temperature is within the allowable range of low value, ventilation conditions, power supply stable and clean working environment, work efficiency and service life of the machine will be greatly improved, and the power consumption will be reduced accordingly.

Three, inspection and installation

A, unpacking and inspection

Pack 1, cut and remove fastening packing box.

2, remove the packaging carton.

3, remove the foam block, peel off the bag on the top of the ice machine.

4, please check the ice machine appearance is damaged.

5, open the package, take out the packing list, check random accessories.

B, installation

1, electrical installation should be stable, in order to ensure the normal operation of the machine, without accident.

2, the location of the machine to have good ventilation and heat dissipation conditions, avoid heat and direct sunlight, each outlet and walls or similar obstacles should have more than 20cm distance.

3, the machine power cord corresponding link, and ensure reliable grounding

4, the supply voltage shall not be less than 200V, the frequency to meet the requirements of the machine.

For the safety of you and others, please ensure that the machine is well grounded, and all the external wiring and electrical appliances shall comply with the relevant national standards

Four, operating instructions

1, the power supply plug Thailand rolling machine equipped with a special insert ground socket inside

2, after the power is turned on, turn on the switch, let the machine pre cooling 10-15 minutes or so, the temperature of -26 degrees or below

3, the slurry is prepared into the pot fried ice machine

4, to be fried after the volume of fried ice, that is, shovel shovel can be put into the dish to be eaten

5, if you find a good fried ice roll and pot body adhesion, then need to open the defrost switch for defrosting (each time defrost about 4-6 seconds), after defrosting should immediately turn off the defrost switch, can be continuously fried ice cream roll

Five, the basic formula

Here we introduce a method of economical and practical formula and specific ingredients to you, the recipe and ingredients familiar by mastering and, by analogy, can be handy fried ice cream rolls of various styles.

Basic formula: fruit puree (or yogurt) 40% water, 20% jam, 10% cream, sugar, 10% ice cream powder, a little flavor of a few (walnut, peanut, sunflower seeds, sesame seeds, etc.); (10%)

Be careful：

1, the formula, the proportion of water and sugar is the economy, if the reduction will affect the quality of fried ice.

2, the ratio of sugar content of not less than 10%.

3, under normal circumstances, the preparation of the slurry temperature is normal, if the slurry ahead of pre cooling, fried ice roll better.

Six, cleaning, disinfection and maintenance

Before the first use of the machine, a thorough cleaning and disinfection should be carried out, the specific methods are as follows:

1, the right amount of food detergent into 2 liters of warm water, into a cleaning disinfectant

2, the cleaning and disinfection liquid into the frying pan for cleaning

3, after cleaning, washing with water poured into the pot, so repeatedly for 2 times

In order to ensure the health of consumers, improve the service life of the machine, to avoid unnecessary trouble, please follow the instructions as follows.

1, every day after the completion of the production, the first power off, and then clean the hot water to clean the surface of the machine, so as to avoid excessive sugar adhesion to the surface of the machine.

2, do not wash the machine directly with water, washing machine with a wet towel to wipe.

3, regular cleaning the condenser inside the machine, use a screwdriver to remove the panel, with a fine brush along the direction of fin sweep dust, cooling function so as to ensure the machine is not affected.

Common faults and troubleshooting (please read the instructions)