厂商 ：上海天祥质量技术服务有限公司
上海 上海- 主营产品：
- 陶瓷测试
- 运动及健身器材测试
- 箱包测试
联系电话 ：13651833403
商品详细描述
| Bags and Luggages (箱包测试) |
| Test Item (测试项目) |
| Static loading test |
| Sample is loaded with a weight 1.5 times the claimed maximum loading capacity (or 0.5kg/dm 3 if the maximum loading capacity not specified) for its intended use then suspended by its carrying handle/shoulder straps for an hour by a belt with width in 80mm.. Assessment is made for any damage capable of impairing safety or function. |
| Dynamic loading test (or jerking test) |
| Sample is loaded with a weight of the claimed maximum loading capacity (or 0.35kg/dm3 if the maximum loading capacity not specified) for its intended use then subjected to N jerking cycles at a frequency of approximately 0.5Hz and an amplitude of 120mm. Assessment is made for any damage capable of impairing safety or function. Not applicable for the item with test loading is more than 20kg. |
| Number of jerking cycles: |
| Main loading bearing handle/shoulder: 2,500 cycles |
| Extended handle: 250 cycle |
| Wheel endurance test |
| EN 13613 clause 6.7 for 32km (Claim from luggage of Samsonite). Retractable handles on suitcases etc shall be fully extended and positioned at 45O and the suitcase tested at this angle. Sample is loaded with a weight of the claimed maximum loading capacity (or 0.35kg/dm3 if the maximum loading capacity not specified). The wheels shall not seize or become damaged following the test. The handle shall not break, crack, distort and shall retract without out any undue force. |
| Compression strength (for luggage) |
| Reference: ISTA 2A. Place the sample on floor, apply a vertical distributed stack load of 150kg on the surface for one hour. Test shall be performed on length, width and height directions of main load bearing structure. Assessment is made for any damage capable of impairing safety or function |
| Zipper durabil(Tested on full luggage) |
| Open/close the main zipper for 1500 cycles, other zippers for 500 cycles. Assessment is made for any damage capable of impairing safety or function.ity |
| Workmanship |
| No major defects by visual check; no non-functional sharp point,
sharp edge. The bottom frame & attachments should be smooth without burrs to avoid any marring for the floor. |
| Conditioning Test on Metal Parts |
| Sample is conditioned at 54 OC with 95% relative humidity for 24 hours. Observation is made for any damage and apparent change of the sample. |
| Drop test |
| Sample is dropped through a height H to an impact medium (use
vinyl tiled concrete floor as the impact medium) for 5 times. Sample is loaded with a weight of the claimed maximum loading capacity (or 0.35kg/dm3 if the maximum loading capacity not specified) Assessment is made for any sharp points/sharp edges/cracks/damage. Fastening devices (locks etc) must remain functional. Drop height H listed as below with reference to ISTA 1A. Total weight (kg) <10 <19 <28 <45 <68 Drop height (cm) 76 61 46 31 20 |
| Lock system durability |
| Open/close the lock for 2000 cycles, assessment is made for any damage capable of impairing safety or function. |
| Durability for telescope sliding handle |
| Unlock the handle and pull to top auto-lock position, and unlock it back to the bottom auto-lock position. Repeat for 1500 cycles. Assessment is made for any damage capable of impairing safety or function. |
| Stability |
| Sample is loaded with a weight of the claimed maximum loading capacity (or 0.35kg/dm3 if the maximum loading capacity not specified) The luggage shall be stable when loaded evenly. |
| Impact test for extended handle |
| Sample is loaded
with a weight
of the claimed
maximum loading capacity
(or 0.35kg/d m3
if the maximum loading
capacity not specified).
Place on the
concrete floor vertically
with the extended handle at the upmost position. Tip
it over by pushing the luggage slowly past it centre of balance to impact the
extended handle for 50 times. There shall be no any damage capable of
impairing safety or function. |
| Bottom foot, attachments strength |
| Apply a force F in horizontal direction for the bottom attachments in 5 seconds and maintain for 10 seconds, there shall be no any damage capable of impairing safety or function. (F is the weight of luggage adding the specified maximum capacity loading or 0.35kg/d m3 if the maximum loading capacity not specified) |
相关产品推荐