厂商 ：东莞市长安明亮清洁机械有限公司
广东 东莞- 主营产品：
- 防静电地板蜡
- 进口石材养护产品
- 花岗岩/瓷砖/养护剂
联系电话 ：15899936696
商品详细描述
生产石材护理 大理石结晶粉 抛光粉 高光泽度结晶粉
大理石纳米硅翻新结晶粉呈白色粉末，高表面活性，无毒，活性好，使用安全。该翻新结晶粉是运用纳米技术配制而成，将大理石打磨至2000#左右，即可使用本结晶粉抛磨至光亮，产生二氧化硅，使之充分填补石板表面微细毛孔，它上光速度快，透气性好，可达到最快速的加硬加光效果。
The marble renovation of nanometer silicon crystalline powder white powder, high surface activity, non-toxic, good activity, safe use. The renovation of crystal powder is prepared using nanotechnology, marble polishing to 2000 or so, can use the crystalline powder grinding to bright, to produce silica, to fully fill the stone surface of fine pores, the polishing speed, good air permeability, can reach the most rapid hardening with light effect.
适用范围：天然大理石
Scope of application: natural marble
使用方法：
１. 做晶面处理前，须将工作场地沙粒灰尘清除干净。然后将粗糙的大理石地面用翻新碟翻新至2000#左右,最后把地面清洗干净。
2. 把翻新结晶粉与清水按1：3（根据实际情况可做相应调整）的比例调成糊状，将其适量涂在大理石表面上，使用晶面机配白色百洁垫或纳米羊毛垫进行打磨。
3. 打磨1-2分钟（根据具体石材调整打磨时间）后用吸水机吸干,用清水清洗干净,然后用干净的白色百洁垫干抛一下，地面即发出钻石般光芒。注意事项：建议选用扭力性能高，转速一般在154转175转/分，重量为50kg以上的晶面机配合使用。
Method of use:
In 1, crystal surface treatment, should be the site of sand dust cleared. And then the coarse marble floor renovation renovation for dish to 2000 # around, finally the floor clean.
In 2, the renovation of crystal powder and water according to 1: 3 ( according to the actual situation can be adjusted accordingly ) proportional to tune into a paste, the amount of coating on the surface of the use of marble, crystal face with white scouring pad or nanometer wool pad for polishing.
In 3, 1-2 minutes ( according to the specific grinding stone adjust grinding time ) later absorbent machine dry, use clean water, and then use a clean white pad dry throwing up, ground namely a diamond-like shine. Note: suggested the use of torsion performance of high speed, generally at 154 rpm to 175 rpm, the weight is more than 50kg crystal face with the use of.
|
产地： |
广东东莞 |
品牌： |
美洁灵 |
适用范围： |
大理石 |
|
防护用途： |
表面石材 |
溶剂类型： |
粉末状 |
溶解性能： |
水性 |
|
溶质成份： |
丙稀酸型 |
作用机理： |
渗透型 |
防护效果： |
综合型 |
|
界面作用力： |
憎水型 |
规格： |
5KG 20KG |
|
|
The marble renovation of nanometer silicon crystalline powder white powder, high surface activity, non-toxic, good activity, safe use. The renovation of crystal powder is prepared using nanotechnology, marble polishing to 2000 or so, can use the crystalline powder grinding to bright, to produce silica, to fully fill the stone surface of fine pores, the polishing speed, good air permeability, can reach the most rapid hardening with light effect.
适用范围：天然大理石
Scope of application: natural marble
使用方法：
１. 做晶面处理前，须将工作场地沙粒灰尘清除干净。然后将粗糙的大理石地面用翻新碟翻新至2000#左右,最后把地面清洗干净。
2. 把翻新结晶粉与清水按1：3（根据实际情况可做相应调整）的比例调成糊状，将其适量涂在大理石表面上，使用晶面机配白色百洁垫或纳米羊毛垫进行打磨。
3. 打磨1-2分钟（根据具体石材调整打磨时间）后用吸水机吸干,用清水清洗干净,然后用干净的白色百洁垫干抛一下，地面即发出钻石般光芒。注意事项：建议选用扭力性能高，转速一般在154转175转/分，重量为50kg以上的晶面机配合使用。
Method of use:
In 1, crystal surface treatment, should be the site of sand dust cleared. And then the coarse marble floor renovation renovation for dish to 2000 # around, finally the floor clean.
In 2, the renovation of crystal powder and water according to 1: 3 ( according to the actual situation can be adjusted accordingly ) proportional to tune into a paste, the amount of coating on the surface of the use of marble, crystal face with white scouring pad or nanometer wool pad for polishing.
In 3, 1-2 minutes ( according to the specific grinding stone adjust grinding time ) later absorbent machine dry, use clean water, and then use a clean white pad dry throwing up, ground namely a diamond-like shine. Note: suggested the use of torsion performance of high speed, generally at 154 rpm to 175 rpm, the weight is more than 50kg crystal face with the use of.
相关产品推荐
