除雾器安装，除雾器技术，除雾器模块，除雾器参数

河北北山环保设备有限公司 1、Technical Description/技术描述 ■1.3 Performance and Operation Data/性能和操作数据 The design and engineering of the Bei Shan.mist eliminator is done with a specialcalculation method and considers all major influences. 北山公司除雾器的设计运用了特殊的计算方法和充分地考虑了全部的主要影响因素。 For this reason the FGD plant must run within the design parameters to assure a higheffective performance of the mist eliminator.This is especially important for the gas flowvelocity,which must be within design range.Local exceeding of the flow velocity is onlyallowed within the given limits.The maximum flow velocity was determined duringengineering from the operation data of the FGD plant and is fixed in the technical datasheets. 因此，脱硫装置必须在设计条件下运行来确保除雾器的性。尤其是对气体流速，气体流速必须在设计范围之内，局部气体偏高只允许在限定的范围之内。在设计过程中，气体流速的确定是从脱硫装置的运行数据表中得到的，他在技术数据表中有确定。 The same must be followed for the operation temperature.To oid damages at the misteliminatorthe mentioned maximum temperature must not be exceeded. 同样，必须保证在操作温度下运行。除雾器的操作温度不能超过允许的温度以避免损坏 ■1.4PressureDrop/压降 The pressure drop of the mist eliminator system is stated in the technical data sheets andis part of the guarantee forthe system.It always refers to clean lamellas and does notconsider negative influences up-or downstream of the mist eliminator. 技术数据表内规定的除雾器压降是系统质保的一部分。它是指叶片在干净情况下的压降，没有考虑除雾器向上及向下气流所造成的消极影响。 Constant measuring of the pressure drop of the mist eliminator is recommended.A highrise of the pressure drop is a hint fora change in the system and activities to get back tothe normal parameters,must be taken. 我们推荐对除雾器的压降进行在线测量。压降的急剧升高是系统产生变化的线索，这时必须采取措施使它回到正常的参数。 —6—