用   途

APPLICATION

◆EDM火花电蚀加工油系列是为电蚀加工专门设计之优异电解液体，适用于各种电火花机的电蚀加工。

◆EDM series are excellent dielectric fluids used for the advance electric discharge operation.

◆EDM L具有良好的冷却性与冲洗作用，其粘度特性能有效地将电蚀产生的金属粉末从加工缝隙中冲出并经过滤去掉，适用于低的电蚀速度以加工出完满的成品表面。

◆EDM L is a good coolant and flushing medium for dispo sal of small metal chip to minimize the carbon cont amination. With low viscosity, it is used for low metal removal rate to give smooth finishes.

◆EDM H为通用的电蚀加工液，广泛应用于各种中等速度电蚀加工。

◆ EDM H is a general purpo se EDM fluid used for intermediate metal removal rates.

◆EDM V具有较高的粘度，适用于快速粗加工，可以提供快速的电蚀速度。

◆EDM V with relatively higher viscosity is used for fast metal removal rate during the roughing process.

特   性

SPECIAL PROPERTIES

◆具有合适的电介质强度，在未达到足够电压的储能阶段作为绝缘介质，当电压达到一定水平时，油液在高压下变为电火花的极好传导介质对工件进行电蚀加工，每次电-击后油液恢复为绝缘体以便电极储存足够的电能产生另一次的火花。

◆Proper dielectric strength so that the oil is an insulator until sufficient voltage is applied at which time it becomes a spark conductor from the tool to the workpiece . Then the fluid must change back to an insulator once again so that electrical energy can be stored for the next spark.

◆合适的低粘度可流经狭窄的火花缝隙而带走金属碎屑以保持油液的清洁及操作性能，良好的热传导性确保良好的冷却作用。

◆Porper low viscosity allow the fluid to circulate through the narrow spark gap and carry away the metal chips. Good heat transfer properties to ensure efficient cooling.

◆高度的抗氧化性确保在高温操作下提供长久的使用寿命并减低淤渣的形成。

◆High oxidation stability to provide long service life and minimize sludge formation.

◆低挥发性和高闪点减低油液损耗及减少油蒸汽的产生，保证了操作者的健康及安好性。

◆Low volatility and high flash point to minimize fluid loss and exp osure of the operator to the vapor and ensure safer operation。

典型数据

TYPICAL DATA

产 品 名 称

粘 度（cSt/40）

闪 点（℃）

 硫 含 量（%）

芳 烃（%）

颜 色

KANUO EDM L

1.8

89

0.001

<0.5

<0.5

KANUO EDM H

2.5

101

0.001

<0.5

<0.5

KANUO EDM V

4.2

120

0.001

<0.5

<0.5