陶瓷喷头清洗机

电源：AC-220-240V  

工作频率：50Hz

超声波功率：80W

加热功率：100W

超声波频率：40Khz

时间控制：0-60分钟（7个时段）

最大容量:1.3L

最高温度：65度

操作步骤：

Step1 打开机器底盖，及清洗液存贮罐盖子。

Open the bottom lid of the machine and the lid of cleaning fluid tank 

Step2 往清洗液存贮罐中倒入清洗液，最少量要没过罐子的出水口。

Pour cleaning fluid into the cleaning fluid tank.. The minimum should be over the water outlet port of the tank

Step3 盖上清洗液存贮罐的盖子，然后盖上清洗机下盖。

Cover the cleaning fluid tank lid .and then the bottom lid of the machine 

Step4 打开机器上盖，把喷头支撑架装到机器上。

Open the top lid and put on nozzle holder 

Step5 把喷头的进墨口接上清洗机的冲洗管。

To connect the inlet of print head to the flushing pipe

Step6 把喷头卡到喷头支撑架上。

To insert the print head into nozzle holder

Step7 装好的喷头。

The inserted print head    

Step8 往清洗槽中倒入清洗液，一直到液面接近出水口。调整喷头固定高度，让喷嘴可以浸泡在清洗液中。

?1?7?1?7Pour cleaning fluid into the cleaning tank ,to close to the water outlet port 

Step9 先设定好喷头清洗时间，一般为1分钟左右。再开启超声波清洗。

First set the nozzle cleaning time, usually about 1 minute. Then turn ultrasonic cleaning.   

Step10 旋钮开启和控制清洗液的循环和流量。

?1?7?1?7Turn control knob and cleaning solution circulation and flow.

 Step11 超声波清洗约1分钟后，拿起喷头支撑架，检查喷头清洗效果。

Release the nozzle holder after ultrasonic cleaning about 1 min. Then press the corresponding green buttom to rinse the print head 

 Step12 反复清洗几次，再按干净的清洗液清洗。直到冲洗时，从喷孔里射出的清洗液整齐，干净后，把喷头清理干净，重新安装上打印机即可。

Repeated cleaning for several times.and Cleaning the print head again after changing the cleaning fluid . Until the cleaning fluid which jet from the nozzle is neat and clean. Then re-install it on the printer after cleaning up the print head