外轴式真空吸附单面瓦楞机

 外轴式真空吸附单机瓦楞机：

Vacuum adsorption single side corrugated machine

⑴    最高工作速度 150 m/min,瓦楞辊直径Φ 310 mm，材质  48crmo合金钢制造，采用热处理工艺精密磨削，经过调质，粗精车，研磨。表面碳化钨处理。

⑶  润滑采用高温油脂润滑形式；

⑷  各导纸轴、预热缸、加压轴工作表面磨削加工并镀硬铬处理。

⑸  浆辊表面采用  30 线/寸精细刻花网纹，表面镀硬铬，使上浆量更少、更均匀。浆盘气动进退。

⑹  数字显示涂胶量。电动隔浆系统：丝杠传动， 100w 齿轮马达减速电机 2台控制，可根据幅宽设定。

⑻  蒸汽压力  1.1-1.2 Mpa，采用金属软管代替虹吸管，使排水更为彻底。

⑼  采用高压离心风机，带有消声器装置。

⑽  各辊疏水系统采用独立疏水，集中回水，取消止回阀、截止阀等旁路设计，合理的回路安装和简便化维护。

⑾ 主电机变频控制。传动为三轴万向节传动方式，由齿轮箱输出的动力分别传至下瓦辊，压力辊和浆辊。

(1)Maximum operating speed of 150 m/min, corrugated roller Φ 310 mm diameter, 48 crmo alloy steel material, the heat treatment process of precision grinding, after tempering, rough finish turning and grinding. On the surface of tungsten carbide processing.

(3) the lubrication in the form of high temperature grease lubrication;

(4) the paper guide shaft, preheating cylinder, plus the concluding work surface grinding and hard chromium plating processing.

5] pulp roll surface using 30 line/inch fine cut, hard chrome plated surface, make the sizing amount less, more even. Pulp plate pneumatic.

[6] figures show the glue. Electric insulation slurry system: screw drive, 100 w two control gear motor reducer motor, it can be set according to the width.

Being 1.1 1.2 Mpa steam pressure, the use of metal hose instead of siphon drainage more thoroughly.

'levies using high pressure centrifugal fan, with a muffler device.

⑽ each roll hydrophobic system USES independent hydrophobic, concentrated backwater, cancel the check valve, stop valve, such as bypass design, reasonable circuit installation and easy maintenance.

⑾ main motor frequency conversion control. Transmission for three-axis gimbal transmission mode, respectively to the gearbox output force under tile roller, pressure roller and plasma roller.