ICPLUS九阳IP1717+IP108A芯片IC

General Description :

The IP1717 is a cost effective and fully integrated single chip. It integrates a 17-port switch controller, an octal PHY transceiver and SSRAM. Each of PHY transceiver complies with 802.3u specification and HP-license Auto MDI/MDIX.                               

The IP1717 also provides a 3S-MII interface to connect an octal PHY for a 16-port dumb switch application and a MII interface for a smart/management switch application.

In addition, it supports full smart switch functions, including IGMP snooping, 4 priority queues, TOS, TCP/UDP port number priority, 802.1Q VLAN, port security, protocol filter/forwarding and bandwidth control.

Feature :

• Built in 8 internal PHY, 8 SS-SMII (SMII), and one MII

• Built in 1.625Mb RAM

• Support packet length up to 1600 Bytes

• Store & forward, share memory, non-blocking architecture  

• Support flow control
  - 802.3x in full duplex 
  - Collision/Carrier_sense based backpressure in half duplex

• Provide up to 4K MAC address entries
  - CRC/ direct hashing algorithm 
  - Programmable aging timer (55s~1812070.4s)

  - Wire speed address learning and resolution

  - CPU accessible for security and static MAC

  - Learning enable/disable

  - IP filter 

• Support Sniffer function (in, out, in & out)  

• Support IGMP snooping function Version 1,2
  - Support up to 2 trunk groups 
  - (Port 0~3, port 4~7)

- Load balance based on (port, DA, SA, DA / SA)

• Support VLAN
  - Port based VLAN 
  - Tag based VLAN based on Ports & VIDs

- Add/ remove/ modify tag

• Support Class of Service

  - Port based CoS function
  - 802.1Q priority tag based
  - IP TOS based (IPv4/IPv6)

  - TCP/UDP port based
  - 4 queues for per port

  - WRR/ FIFS/ SP algorithm 

• Broadcast storm control support

  - Broadcast rate control per port

  - Block broadcast packet that not belongs to ARP or IPv4 packet to CPU port

• Support port security

  - MAC address based
  - IP address based

• Supports Bandwidth control

  - 255 configurable levels for P0~P16, (from 32kbps to 7.96 Mbps) for low bandwidth

  - 255 configurable levels for P0-P16 (from 512kbps to 100 Mbps) for high bandwidth 
  - With/without flow control

• Support SMI auto-polling function

  - Poll for speed, duplex, flow control, and link
  - CPU accessible (interrupt support)

• CPU R/W PHY registers

• Support SS_SMII and SMII mode

• Support 4 port states for Spanning Tree protocol

  - Discarding/Blocking/learning/ forwarding 
  - Forward BPDU to CPU port

• Captures specific packet to CPU port
• BPDU, LACP, 802.1X, GMRP, GVRP, ARP

• ICMP, IGMP, TCP, UDP, OSPF, other IP protocols
  - Packets with specific TCP/UDP port number

• Flexible PHY address setting for CPU  

• Support three Configuration modes

  - Pin initial setting

  - 2 wire serial interface for EEPROM 
  - 2 wire serial interface for CPU

• Statistic counters for each port

  - RX/TX packet count

  - CRC error packet count 
  - Drop packet count

  - Collision count

• Support force link without SMI for Port16

• Support Non association port

• Support port based address flush  

• Support LED functions (for p0~p7)

  - Support 2 bit serial,3 bit serial, and 3 bit bi color mode

  - Support direct LED mode for Link/Activity, speed, duplex states 
  - Support bi color direct LED mode

• Only one 25MHz crystal is needed

• Adjustable IO voltage (3.3v MII1.95V SS-SMII)

• Programmable MAC address table through CPU interface

• 128 pin PQFP Lead free package